Hi guys,
The 3 way on my resurrection leaks but only a very very minor one, to the point where it has to be left for 20 mins or so to make a difference in pressure reading on my tank. Its not a massive issue, but is annoying none the less. It leaks from the tiny vent hole on the top front just infront of the first hose. Iv'e tried changing the o-rings on the 3 way rod, backing the rod all the way out and messing with the lpr pressures but to no success. Anything else anyone who's much better with cockers than I am can think of?#
Cheers
The 3 way on my resurrection leaks but only a very very minor one, to the point where it has to be left for 20 mins or so to make a difference in pressure reading on my tank. Its not a massive issue, but is annoying none the less. It leaks from the tiny vent hole on the top front just infront of the first hose. Iv'e tried changing the o-rings on the 3 way rod, backing the rod all the way out and messing with the lpr pressures but to no success. Anything else anyone who's much better with cockers than I am can think of?#
Cheers
It sounds like you've tried a lot of the first steps, the other issue that can cause such a leak is the ram. If the piston o-ring is leaking or the sealant between the piston head and shaft isn't good then it will leak air past, go back to the three way and cause the leak you are describing.
