05 alias tintimidator problems

[gun_grunt]

iv just got a new timmy and it isent working proply but i cant find the problem sorce the air is working fine up until it hits themain gun it goes through the hose and into the reg but were the reg conects to the gun i just it just stops if someone can give me a hand id be gratefull thanx adam

 

[Lump]

what postion is the LPR screw at ?

 

[gun_grunt]

hi

lol sorry ahbout my stupidaty but witch one is it

 

[Lump]

ok if you dont know that then you are going to be in a bit of trouble so go here

http://www.pbnation.com/showthread.php?t=26282

there will be every bit of information you will need on a timmy just take your time and read through them ok

 

[gun_grunt]

hmm

still cant find the problem when u turn it on the its basicle notputting any air into the gun but i no its going through the reg

 

[Mario]

Sounds like you haven't set your LPR right then. If you are sure its going into the HPR (the one directly from your on/off) then give the screw underneath the barrel a couple of turns in and that should start putting some air through. Do it slowly though...I believe its supposed to run at around 75psi?!? Thats what i ran mine at...

 

[Bon]

Unscrew both screws untill they are flush with the ends of the regs.

Screw the HPR (the bottem one) in 4-5 full turns.

Then screw the LPR in (the 1 by the barrel)(slowly) untill the guage reads 60-80 psi

That should put you in the area of 280-300 fps

Adjust your hpr untill you get the right fps.. screw in to turn up, screw out to lower...

 

[gun_grunt]

ok cool

ok guys thanx for all your help im up and running and its the sweetest its ever sounded lol thanx