GEO 2 speed problem
- Thread starter Audrius
- Start date
Did you get this sorted? You can MacGyver a fix by restricting the volume of the air behind the bolt. I know some of the reball teams in sweden used to use tape for that.
hello one more questions about GEO 2.1
its winter we are training in indoor field but temperature is low like +2+7 and my geo 3.1 works great but friends 2.1 some times starting break paint near bolt system so if I set dwell higher does it helps for better and smoother shot ?
Thank you for your answers
its winter we are training in indoor field but temperature is low like +2+7 and my geo 3.1 works great but friends 2.1 some times starting break paint near bolt system so if I set dwell higher does it helps for better and smoother shot ?
Thank you for your answers
Fresh quality battery ?
Settings ?
Which paintballs (fresh/fragile) ?
There can be a number of reason here.
Setting the Dwell higher is only going to waste more air than you need.
Set dwell @stock 12.5ms
Stock barrel ? 0.689
Hopper can have too much tension on the ball stack.
Paint can be already cracked before it enters the breech.
Settings ?
Which paintballs (fresh/fragile) ?
There can be a number of reason here.
Setting the Dwell higher is only going to waste more air than you need.
Set dwell @stock 12.5ms
Stock barrel ? 0.689
Hopper can have too much tension on the ball stack.
Paint can be already cracked before it enters the breech.
Paint are fresh
factory settings MS10
Stock barrel
dye rotor
same box of paint team are playing with geo2.1 and 3.1
what I want is how to make slower smoother bolt for paint
factory settings MS10
Stock barrel
dye rotor
same box of paint team are playing with geo2.1 and 3.1
what I want is how to make slower smoother bolt for paint
Have you checked the detents if they are worn ?
My 2.1 is completely stock, stock settings, and is very smooth. Never had problems in low temps, but then i was using winter paint.
You cannot slow down the bolt action on the 2.1
@ what velocity was the 2.1 shooting (FPS) ?
You could lower the FPS a fraction down by 10 fps. This would help slightly when playing in low temps.
My 2.1 is completely stock, stock settings, and is very smooth. Never had problems in low temps, but then i was using winter paint.
You cannot slow down the bolt action on the 2.1
@ what velocity was the 2.1 shooting (FPS) ?
You could lower the FPS a fraction down by 10 fps. This would help slightly when playing in low temps.
heads up, you can reduce the tension on your rotor as well by screwing the adjustment screw on the front of the motor anticlockwise in case the paint is too fragile for the loader, it might be smashing it as it lands in the breach.