Welcome To P8ntballer.com
The Home Of European Paintball
Sign Up & Join In

DM 12 Leak

Dygrasi

Member
Jul 8, 2012
17
2
13
49
Norway
New to DMs and this one is leaking from the lpr. I bought it used and it was in a rater bad shape.
I replaced all the o-rings in the lpr, but what i wondering a bout is the set screw, is there more than one and if not in what hole should i place the screw in.
And if there is more than 1 are they the same?
 

tricky m

Well-Known Member
Feb 17, 2010
673
230
98
leeds
If its the same as older dm's. There are two grub screws under body. One holds the lpr in place. The other is a blanking screw. To block the milling air feed to bolt The front one will want loctited on it. The rear one should be OK without.
 

Pandamonium

Well-Known Member
Oct 10, 2012
495
58
48
The LPR has to go back into ybe body in a certain way. Make sure that's the case, then see about turning the LPR in a little and see if the air eventually cuts to the bolt. Also is the marker cycling?
 

Dygrasi

Member
Jul 8, 2012
17
2
13
49
Norway
ATM i dont know, im out off air. But it helped to know that one hole was to keep the lpr at bay and the other just sealed.