Welcome To P8ntballer.com
The Home Of European Paintball
Sign Up & Join In

How to replace HP reg.

Status
Not open for further replies.

Gonzo47

..si vis pacem para bellum..
Mar 17, 2011
69
2
18
London
Hello,

Any ideas/ suggestions how to replace the regulator on "Dye Throttle"? It had never been undone/ replaced ant sits very tight. Any methods or tips how to make it not so tight/ loose it to make easier to undo?

Thank You.
 

BOD

The brotherhood
Aug 1, 2003
747
232
68
YORK
Visit site
What that video doesn't say is, if the reg has been put on using a thread locker you will need to apply heat to break the grip of the thread locker, i usually do this by sitting the bottle reg down in mug of near boiling hot water for 10 minutes or so before trying to unscrew it.
 
  • Like
Reactions: Gonzo47

onasilverbike

I'm a country member!
Make sure your tank is completely drained, take the fill nipple, gauge and burst disks out, preferably using the correct 7/16 AF spanner, off the reg and then clamp it in a soft jawed vice or between blocks of soft wood and use a strap wrench on the tank body. If it's tight and doesn't loosen with little effort either leave it on top of a radiator for a couple of hours or immerse it in a bucket of hot water and try again,

If there is any damage to the threads inside the tank neck it will fail a re-test on the visual inspection!

When installing the new reg, or replacing the old one, always use a new O-ring, or expect it to leak around the neck!
 
  • Like
Reactions: Gonzo47
Status
Not open for further replies.