Invert mini cutting paint?

[Liam Woinson]

Hi guys

I have just put a shockwave board in my mini and now it is cutting paint. What setting do I need to change on the board to stop it?

 

[darkfirepheonix]

Hi @Liam Woinson , Putting a new board in shouldn't cause any chopping issues. However to double check have you tried simply swapping the boards back and shooting the same paint? using the same battery? I suspect its more likely a paint issue.

 

[Liam Woinson]

I'm thinking that the fps may be high. I set it to 290 but the screw seemed to go in more than what it was set to. Will try 're setting that as it could be shooting way high for some reason if that could be the cause? Not sure how I can set it on the crono then it be so high it's blowing paint up.

I may also try changing the poppet