Welcome To P8ntballer.com
The Home Of European Paintball
Sign Up & Join In

Invert mini trigger not working

Liam Woinson

Active Member
May 11, 2017
38
1
28
28
Burnley
I have come to set my mini back up and the trigger is not working? None of the pins on the board are bent. When you take the magnet off the trigger and do it by hand it works fine?? Not sure what is up

Any help would be great please? I'm think just getting a new trigger and sensor board but not sure if it is something simple before spending the money lol
 

darkfirepheonix

Paintball/Electronics Tech
Dec 5, 2011
289
19
38
Ipswich
I assume based on your other question posted that this is a V2 Invert Mini, The trigger magnet needs to almost touch the diode so if it is working when you take it off the trigger you have 1 of 2 problems. Magnet is too close so it thinks the trigger is permanently held down, or is too far away meaning it never gets close enough to sense that the trigger has been pulled.
Back all the grub screws out on the trigger so they are all flush is a good starting point.
 

Liam Woinson

Active Member
May 11, 2017
38
1
28
28
Burnley
Turns out I lost the small magnet on the body what sits the other side of the switch I just need to sort out a new magnet which will fit and it should be working again