Welcome To P8ntballer.com
The Home Of European Paintball
Sign Up & Join In

pmr 10 bolt problem

uther313

uther
Sep 4, 2007
421
16
38
Wrexham
Hi guys I have recently picked up a pmr 10 that had a problem with the bolt getting stuck forward and leaking I have sorted the leak out but the bolt is still getting stuck. When it stuck it doesn't leak at all no noise and it only takes tiny push to make it snap back in place. The board settings are all stock and the bolt is lubed up and iv had a look at the hpr as well and seems fine any ideas?
Cheers
 

_d4Mn_

Active Member
Mar 26, 2017
34
0
26
34
Corby
I had a very similar problem with my DM15 2 weeks ago. The bolt stucked a bit and was leaking a bit of air. After replacing the O-rings, the leaking stopped but came back after a few minutes.

What happened was, I have put in the eye-pipe wrong and was scratching the o-rings. After a few shots the scracth was that huge that the o-ring stated to leak. This also made the bolt stuck. Just replaced the eye-pipe and the problem was sorted.

I am unsure if the PMR10 have eye-pipe or not. This model might not have it. but hopefully it helps to someone.