valken vmax + empire axe feedneck

[Wile E Coyote]

bought it a week ago, only to realise it doesn't fit the standard feedneck of my empire axe... not stressful at all!
the feedneck on the vmax is too short which leaves a gap of about half an inch.
am i right in thinking this gap will cause force fed balls to 'offset' and cause blockages, or breaks?

 

[Jim Jam]

bought it a week ago, only to realise it doesn't fit the standard feedneck of my empire axe... not stressful at all!
the feedneck on the vmax is too short which leaves a gap of about half an inch.
am i right in thinking this gap will cause force fed balls to 'offset' and cause blockages, or breaks?

You bought it off me mate, i'm sorry about it not fitting your axe.

 

[GRIMLOCK]

the axe has eyes so chops are unlikely, breaks have little to do with the loader and more the paint and from what ive seen i would worry more about force feed capabilities of the v-max itself.....

 

[Jim Jam]

the axe has eyes so chops are unlikely, breaks have little to do with the loader and more the paint and from what ive seen i would worry more about force feed capabilities of the v-max itself.....

I had no problems with it feeding at 12.5 bps ramping, on a Vanguard creed.

 

[Wile E Coyote]

its ok chaps, going to go into college and turn myself a spacer for it ^_^
plan is to place some blu tack onto the 'ledge' in the feedneck and push the hopper in as far as it can go. the thickness of the blu tack will be the thickness of the spacer!
will make it out of plastic... = )