why wont

[unleash the freak]

my reg wont fit on his marker is a mongoose2, the joints seem to tighten up i wont say the went really tight

 

[unleash the freak]

tried 3 batteries and adjusted the dwell after the marker wouldn't work at the beginning, thats what the manual says

 

[JTD1993]

Did you turn the dwell up or down?

Joe

 

[unleash the freak]

i went through all the setting, the factory set dwell was 15 so went up to 40 then started again from 1 back up to 15

 

[Jesus]

stock dwell is 18 but that isnt the problem here

 

[Jesus]

stock LPR is 5 turns out, HPR is 3 if i remember rightly.

 

[Lump]

check the lpr and hp grub screws, if the are not at recommended setting no air will pass

the lpr seems to be ok, whats the hp grub screws tho not to sure?

Is the gun gassing up.

When you turn the gas on do the macroline joints tighten up

so if air is getting out of your oops ? and air is tightening the macro line ? and the lpr hp is right ??? check back when you have looked at these

 

[unleash the freak]

yep checked all these it still doesnt like me

 

[Lump]

ok next it to take out the bolt to see if an oring has split. which will hold the bolt still. whilst you have the bolt out turn on your air and see if it pisses though into the chamber ! if it dont then go back through the whole thing

 

[unleash the freak]

ive tried all that and re checked the reg, air, macro line etc and still nothing. i took it back to the shop where i got it from, they hav a dye tech there and even he couldnt find a problem with it so he's sent it back to get it checked by dye themselves. thanks for all the advice tho guys!!!