Welcome To P8ntballer.com
The Home Of European Paintball
Sign Up & Join In

z2 sticky

mark haddock

if at 1st u dont succeed hit it harder
May 17, 2012
86
8
18
ipswich suffolk
switch on z2 and intermittant it jams and wont spin just put new board in and new procells but problem pesists anybody had a faulty motor at all? any help welcome
 

phil-boy

UK Redskins
May 6, 2004
3,379
770
148
Essex, UK
www.uk-redskins.com
I personally have not had any problems with mine but have been told of a way of resetting to standard factory settings - press and hold the 2 buttons and switch on, hold for approx 10-15 seconds and then I think it flashes purple (i think) and then release and then it should be the standard settings and work fine.

If not then give Kee a call and I'm sure they will be happy to help out.
 
  • Like
Reactions: mark haddock

Liam92

#16 Reading Entity
Nov 4, 2009
2,371
587
148
Glasgow, Scotland
done reset seams to work might have to use it at walk on b4 f5
Don't get why a brand new board wouldn't have fixed this then? Obviously no way of checking now but i think the problem may have been that the belt might not have been on the pully properly, or the sprocket not seated properly which would mean the loader would try and spin, but might be slipping.
 

mark haddock

if at 1st u dont succeed hit it harder
May 17, 2012
86
8
18
ipswich suffolk
what i was told by kee was any paint gets on board can cause short circuit. but ill check pulley and belt only sticks intermittant like there maybe a point in the motor that gets stuck was what i was wondering