Hyper 3 reg parts.

[BayBlade]

Right I have an NT10 with a red/black hyper 3 reg, foot is selling an hyper 3 in red.
My question is would the red body and swivel from any hyper 3 fit any other hyper 3 reg.

Dye mad some reg with different top caps and to fit different marks, me and foot are 99% that his reg would not fit my marker but will the other parts be interchangeable.

 

[Thib]

Yes, all the Dye Hyper3 regulators are the same but the Proto Hyper3 are slightly different, on those it would still fit and works, but it would look strange.


Edit: Only the top part with the marker fitting are different, but you can swap them over.

 

[BayBlade]

@Marc0 is that right

 

[foot]

@Thib has just confimed what i thought.

Aslong as you use the top of your NT reg my reg will fit.

 

[Marc0]

Like thib say as long as you use the top section of your existing reg and switch out the collar and lower section you will be fine.

 

[Marc0]

You can see the the sections in this picture, you will need to disassemble both regs and switch the main body top section.

 

[Marc0]

Can you take a picture of your reg, you may have the angled swivel collar like in my picture which was only available in black as an aftermarket upgrade.

 

[Captain bitchslap]

I believe the best way to tell between whether its a retro or regular top cap is by what Allen key is needed to undo the top cap. I believe if its a regular hyper 3 top cap it requires the same Allen key as the one used in the brass screw to adjust the regulator