Planet Eclipse Manic Paintball G.I Milsim Tipmann BZ Paintball DYE Paintball Valken Paintball

DM15 Air Troubles

Discussion in 'Tech Troubles' started by Lighthouse, Feb 1, 2017.

  1. Lighthouse Active Member

    Lighthouse
    Joined:
    Jul 24, 2013
    Message Count:
    41
    Likes Received:
    4
    Trophy Points:
    28
    Hi All,

    Was using my DM a couple of weeks ago and air began leaking quite strongly from under the grip. After a brief inspection I noticed that the green 012 o-ring which sits between the frame and the body had come loose, which was probably due to me not screwing the frame and body back together tightly enough last time I attempted maintenance.

    I think I have put everything back together correctly, however I now cannot gas up the marker. I put the air tank on, but the air resistance is just too strong to turn on the air port. Have I put it together incorrectly again or do I have some other fault?

    Many thanks

    Ali
     
  2. Goofy New Member

    Goofy
    Joined:
    Feb 14, 2017
    Message Count:
    1
    Likes Received:
    0
    Trophy Points:
    1
    Hi. Looking into your airport and check if the pin is Allan the way on ir not. If it os then dont attempt to turnon the air.
    Take you dye tool kit and take out the parte inferior frontal oficial the pin to try and get the pin out.
     

Share This Page

Planet Eclipse Manic Paintball G.I Milsim Tipmann BZ Paintball DYE Paintball Valken Paintball