Etek Board help.

[olympus]

I wanna try out the millenium 10bps.

And I have read the manual but I don't think its very clear and don't get it.

I was hoping some kind gent could post up a step by step how to set the board to 10bps.

I know this is dumb but I just dont want to mess this up.

Huge thanks in advance.

 

[Cam Mc]

Etek / Etek 2

1. Enter the Setup menu;
2. Select Firing Mode (red) and set the value to 05.0 (Ramp 3);
3. Select Maximum ROF (green) and set the value to 11.8*;
4. Select Maximum ROF with BBSS Disabled (blue) and set the value to 11.8*;
5. Exit the Setup menu;
6. Check the rate of fire on a league approved ROF meter.

There ya go mate,

Nicky T told me how

Cam

 

[olympus]

Thanks but could you specify which buttons to press th E,G or O
cause it just say push button in the manual....I dont get it?

 

[Cam Mc]

you control parameters with the ON button and the trigger.

the E G O are just to show the modes that you are in.

in set-up mode, hold the trigger until the E goes RED then press the on button until the G goes RED pull the trigger 5 times then press the ON button twice, this will make the E G O flash green,

Congratulations, you are now in RAMP 3.

Cam

 

[Sabot]

The flashes are

when E flashes this changes the Tens

when G flashes this changes the Units

when 0 flashes this changes the small changes 0.1 of a unit

 

[olympus]

Ramp 3!?
is that 10bps?

 

[Cam Mc]

to set it to 10bps

go into set-up mode.

when the G goes RED press the ON button ONCE.

This will make the G go GREEN, hold the trigger until the E goes GREEN

Pull the trigger ONCE, press the ON button twice until the E G O go GREEN at the same time.

Congratulations, 10bps on ramp mode(BBSS on)

If you want any more help, ASK

Cam

 

[olympus]

Thanks a mill' dude!!!!

I'll let you know how things go!