sp ephiphany issue

[no-infernomark]

Hello all

Its been a while since iv tinkered witha gun however im in need of knowledge.
I have the sp ephiphany with fitebolt cp reg and blackheart board. When i gas up it goes on the gauge 260psi which is in its range I believe. However it doesnt shoot it just hisses. However when I lower it to 200 it fires but over chrono its 240fps. Obviously looking for 280. I remember owning a vibe and it would vent when its over pressured.
Now the question is: is this a temperature issue, a dwell issue or an internal issue I.e lube or noid issue.

Thanks all

 

[deaallen]

Sounds like either a dwell issue or a battery issue, try a fresh battery and try a factory reset on the board

 

[no-infernomark]

Iv changed the battery but for some reason it will power up but not stay on with a duracell procell but will with a cheapy.

 

[deaallen]

That's not right.... are the wires all ok, no weak connections at all?

 

[no-infernomark]

No iv had a look and everything looks fine. iv took the green insert out of the fire can and still won't fire at over 200psi it just vents out the noid. I have a feeling the noid is shot. Gonna give it a lube and see what happens.