nt11 bolt not returning.

[Sam F]

I have the oled board, it's set at 18, which is equivalent to the standard boards 9. I'll pick it up in an hour or so and see what happens

 

[slam]

Just an idea but the last time you used the nt did you adjust the velocity using the in line reg?

 

[renie]

take the front oring off the bolt tip and see if it still does it I had a similar problem where the tip oring was catching on the eye pipe

 

[Sam F]

Just ran a handful of balls through it, dwell upped, but same as before, should have been more clear, it cycles back fine most times but then gets stuck out. Possibly once in every 5 shots. Have to turn eyes off, fire and then carry on.

 

[Sam F]

Just a few pics of what I can see going on although this is not exact place bolt is stopping, is roughly

 

[benHK]

So turning the eyes off makes the gun shoot? Try removing the eye pipe and making sure the rubber eye seal is properly seated. Maybe its not in the right position so its putting pressure on the eye pipe causing the bolt to stick? In the photo its stuck by the eye seal, so if the bolt gets stuck and covers the eyes, then the eyes will think theres a fault and wont let you shoot, unless you turn them off

 

[niloc65]

@Captain bitchslap do you have any thoughts for this NT11 owner ?

 

[Sam F]

He has been in contact! Some great help, not had a chance to sort yet!

 

[movingcanvass]

Yeah I'd go with the dwell, no harm in playing with it

 

[lettucecheesecake]

That last pic it looks like the bolt is rubbing on something. Maybe see if thats your problem