anodisind
- Thread starter frosty
- Start date
www.slothball.com
These guys ROCK hunderd percent!!! (insert Dutch accent)
Top quality annodising at Netto prices.
These guys ROCK hunderd percent!!! (insert Dutch accent)
Top quality annodising at Netto prices.
dont quote me on this, but i believe those guys will re-anno a whole gun + barrel etc for £70 which doesnt seem bad to me
OK. I do some anodizing with Dirt Products, so I have some opinions here:
The Ion frame is milled from a cast aluminum piece. The alloy used is a 2011 or something like that, and it will not ano as nicely as 6061. The Shockers are similar. Apparently, Smart Parts uses a softer aluminum alloy so that they can run the CNC a little faster. A few seconds here and there adds up to saving a lot of money, afetr all. Shockers can for sure be re-ano'ed... not as certain about Ions. I know those grip frames come from SP with a powder coated finish, but that isn't too tough to remove. How well they will anodize is questionable. Might be ok... I haven't done any of them personally.
The Ion frame is milled from a cast aluminum piece. The alloy used is a 2011 or something like that, and it will not ano as nicely as 6061. The Shockers are similar. Apparently, Smart Parts uses a softer aluminum alloy so that they can run the CNC a little faster. A few seconds here and there adds up to saving a lot of money, afetr all. Shockers can for sure be re-ano'ed... not as certain about Ions. I know those grip frames come from SP with a powder coated finish, but that isn't too tough to remove. How well they will anodize is questionable. Might be ok... I haven't done any of them personally.