i need a more efficient marker
- Thread starter chris w
- Start date
why do you need something more efficient, pmr's arent amzingly bad, if you want efficieny get a rammer based marker, ego most likely
yup basicly
chris
My DM started to run un-efficiently, so i took the bolt out and cleaned the cylinder and top hat of all lube that was obstructing the wholes. the lube had been in the wholes long enough to go off and become more viscous not allowing an efficient air flow
perhaps try this?
im not sure as im using a steely atm, but the spec says its around... 1200 from a 68/45 i think :S
and, magic ill try this next time i use it
as iv only used to for about 4000 shots im not sure this would of become too much of a problem?
ill try it anyway, its not guna harm me
thanks
and, magic ill try this next time i use it
as iv only used to for about 4000 shots im not sure this would of become too much of a problem?
ill try it anyway, its not guna harm me
thanks
Worth trying before spending any cashim not sure as im using a steely atm, but the spec says its around... 1200 from a 68/45 i think :S
and, magic ill try this next time i use it
as iv only used to for about 4000 shots im not sure this would of become too much of a problem?
ill try it anyway, its not guna harm me
thanks
hope it helps
4000 shots, ask again after anothe 5 cases. Give everything chance to break in, efficiency and consistency will both increase, then optimise your settings, lpr, dwell etc.im not sure as im using a steely atm, but the spec says its around... 1200 from a 68/45 i think :S
and, magic ill try this next time i use it
as iv only used to for about 4000 shots im not sure this would of become too much of a problem?
ill try it anyway, its not guna harm me
thanks