Dying mask
- Thread starter Adam Axford
- Start date
yep, acrylic spray paint 
google Kobra spray paint.
tip: avoid the low stuff. the standard stuff works best
google Kobra spray paint.
tip: avoid the low stuff. the standard stuff works best
Cheers! Now which colour to go for!yep, acrylic spray paint
google Kobra spray paint.
tip: avoid the low stuff. the standard stuff works best
Did you take your foam out first?
on the mask in the pic, i bought it cheap and with little foam left. i did strip out the remaining foam.
you will be amazed with the range of colours they do, 100+ if i remember rightly
my next test will be with fluorescent colours
you will be amazed with the range of colours they do, 100+ if i remember rightly
my next test will be with fluorescent colours
pretty much any PB shop can order it in. if you remove yours, maybe just glue it back in if its still decent?
also, when i went to remove my foam, i also removed the foam base as well (the solid foam thingy between the foam and mask)
also, when i went to remove my foam, i also removed the foam base as well (the solid foam thingy between the foam and mask)
it sounds it but it was simply for me. when i tried to remove the soft foam, it started to rip so i went for the hard part, came out a lot easier. that could be down to the soft foam being reglued or whatnot.
masking it would be easier overall. maybe use masking on opposite side of vents too to stop inner spray
masking it would be easier overall. maybe use masking on opposite side of vents too to stop inner spray
yep, didnt see much point coating the inside. plus if it did flake in the future, didnt want to be inhaling it